Products Category
Heracles Wheel Loader
Contact Us
Tel: +86-13165000892
E-mail: [email protected]
E-mail: [email protected]
Add: Qingzhou,Shandong,China
Company News
>> Heracles loaders h180 Ensure normal working load
Heracles loaders h180 Ensure normal working load
The heracles loaders h180 magnitude and nature of working load of h580 heracles loaderhave an important influence on the loss process of h580 heracles loader. Generally speaking, the wear of parts increases proportionally with the increase of load. When the load borne by the part is higher than the average design load, its wear will increase. In addition, when other conditions are the same, the wear under stable load is smaller than that under dynamic load, with fewer failures and lower service life. The h580 heracles loadertest shows that the wear of the cylinder will increase by two times when the engine works under unstable load compared with stable load. The engine working under normal load has low failure rate and long service life. On the contrary, if the engine is overloaded, the failure rate will increase significantly, and the service life will also be less than the design index. The wear of excavators that are often in a wide range of load changes is greater than that of excavators that work continuously and stably. In general, the engine used by the generator has a longer service life than that used by bulldozers,heracles loaders h180, etc. heracles loaders h180 The normal h180 front end loader working load mainly depends on the use of the excavator by the operator. First, pay attention not to work under the maximum load that the excavator can bear, and use the excavator within the capacity. As the h580 heracles loader manager, when assigning the operator, he/she should hand over the data and operation manual attached to the excavator to the operator so that he/she can correctly master the excavator performance and operation process, and should not arbitrarily withhold the relevant data. Second, h180 front end loader should try to ensure that the h180 front end loader load is evenly increased or decreased, so that the excavator is in a relatively gentle load change. Specifically, we should increase or decrease the throttle more evenly to prevent the action of the engine and working device from rising and falling.
Chinese
Deutsch
Espanol
Francais
Italiano
Portugues
Japanese
Korean
Arabic
Russian
