Shandong Heracles Machinery Co., Ltd

The correct use and maintenance of forklift will prolong the service life, reduce the failure rate and improve the efficiency.

 

1.  RAPTO HL18 loader Clean and wipe it clean every day; www.heraclesloader.com

 

2.RAPTO HL18 loader Check the leakage of working oil, fuel oil and water;

 

3.RAPTO HL18 loader Water tank inspection;

 

Remove the water tank cover and observe through the orifice. If the coolant level remains high, reinstall the water tank cover. If the liquid level drops, add water. Pay attention to add tap water and do not add dirty water. When checking the water tank, pay special attention to prevent scalding caused by hot steam.

 

4. RAPTO HL18 loader Air filter inspection

 

Use compressed air to blow away dust or dirt, and pay attention to blowing from inside to outside; Check the folded part for damage.

 

5. RAPTO HL18 loader  Pipeline and oil cylinder inspection;

 

Check whether there is oil leakage in the hydraulic pipeline and cylinder 3.

 

6. RAPTO HL18 loader Inspection of shelf (gantry)

 

Remove the filler cap, check whether the oil level is within the scale of the scale, and check the fastening of the mounting bolts of the stop shelf (gantry) and the fork frame. If they are loose, tighten them.

 

7.RAPTO HL18 loader Battery electrolyte inspection

 

Observe whether the battery electrolyte is between the scale lines on the battery box. If it is below the scale line, add electrolyte, but it shall not exceed the range of the scale line.

 

8.  RAPTO HL18 loader Engine oil level check

 

Take out the diesel oil dipstick, wipe it, insert it, and then take it out to observe the oil level. The oil level should be between the scales of the oil scale. When checking the oil level, if it is cold oil, the oil level cannot be reflected correctly.